HONDA 1980-83 GL1100 GOLDWING Polished Stainless Steel Engine Bolt Kit Set

Here is a great way to dress up your 1983-80 Honda GL1100 Goldwing and get rid of those rusted, oxidized bolts with this beautiful polished 100% stainless steel 162 Piece Allen bolt kit for the Honda engine. A similar kit from a polish shop will cost you over $275.

Installing this kit is very simple. Just remove one bolt at a time and replace it with the correct bolt and washer from the kit and tighten. All component kits are seperated and clearly marked as to where they go.

These bolts are great looking and will not rust.

This kit consists of the following individually packaged and labeled component kits:

CDI/ Pulser Cover, Final Shaft Cover, Intakes & Exhaust Flanges, Clutch Cover, Fuel Pump, Rear Cover, Transmission Cover, Water Pump Cover, Thermostat and Pipe, Starter Mount.

We use Allen bolts with our custom made washers for proper coverage to replace the old stock panhead screws. We use Socket flathead screws to replace the Ovalheads so the new bolts all match in appearance.

These fasteners have been through our polishing process and the finish is much brighter than a standard stainless steel bolt.

The photo is of our similar GL1000 kit we offer.